The Mapping settings provide access to MIDI parameters such as channel, Pitch Bend range, and Control Change (CC). These settings allow you to send CC messages to your DAW or synth corresponding to various touch dimensions: absolute X, absolute Y, pressure Z, relative X, and relative Y (all explained in detail). Additionally, it displays the channel number of the active element in the current layout.

Out routing

• USB device out: On/Off
• MIDI Out A: On/Off
• MIDI Out B: On/Off
• USB Host out: On/Off

MPE

On/Off

Channel

MIDI 1 →  [1;16]
MIDI MPE → (Channel 1, 16) - equivalent to Low and High registers

PB Range

Pitch bend range is set to 12 semitones by default when MPE is off and 28 semitones when it’s on

Pressure

On/Off - Pressure is Mapped to a CC to the pressure

‍

X & Y  Abs

X abs

Map a CC value to X abs - corresponds to the X-axis (horizontal) position in a cartesian frame of reference where (0) is at the left of the key and (127) on the right. You can set the Min/Max range in the Lab.

Y Abs

Map a CC value to Y abs - corresponds to the Y-axis (vertical) position in a cartesian frame of reference where (0) is at the bottom of the key and (127) at the top right hand corner. You can set the Min/Max range in the Lab.

‍

X & Y Rel

X Rel‍

Map a CC value to X Rel - corresponds to the relative displacement in the X-axis (horizontal) in a cartesian frame of reference where default value 63 is at the onset touch location. You can set the Initial Value in the Lab as well as the Min/Max range. 

Y Rel‍

Map a CC value to Y Rel - corresponds to the relative displacement in the Y-axis (vertical) position  in a cartesian frame of reference where default value 63 is at the onset touch location. You can set the Initial Value in the Lab as well as the Min/Max range. Within the Mapping settings, you can find MIDI parameters such as channel, Pitchbend range, Control Change (CC). The main purpose is to send your DAW or synth the control change (CC) corresponding to the different touch dimensions : abs X , abs Y , pressure Z , rel X and rel Y (all explained . It also displays the channel number from the active element on the current layout.